Power Viewer Mobile 2 play online

With the new Power Viewer Mobile 2 App you are able to use all Rohde&Schwarz NRP series RF Power Sensor with your Android smartphone or tablet.
Requirements:
o\tR&SNRP Power Sensor
o\tR&SNRP-Zxx Power Sensor
o\tDevice with Android 5.0 or higher
o\tUSB-OTG adapter cable (If the sensors should be used via USB)
o\tNetwork connection with PoE (If Network Sensors should be used)

Optionally a USB hub can be used to connect more than one USB sensor to the Android device.

Supported Features:
o\tContinuous average mode
o\tTrace mode
o\tUp to four sensors simultaneously
o\tSupport for Measurement over Network (with R&SNRP-xxXN power sensors)
o\tFlexible user interface
o\tExtensive settings for the supported measurement modes

Important:
This app depends on a working USB host (USB On The Go) controller built into your device. Some smartphones block high-power USB devices. In this case only the sensors with low supply power requirements will work, or the use of a self-powered USB hub is necessary.
The Trace Measure mode is only available with Sensors with support of this mode. If a Sensor doesnt support this mode, nothing will be shown if switching to the Trace mode.

Warning:
Connecting an R&SNRP power sensor to the USB port of your Android device will drain your battery regardless whether this app is active or not. Make sure to disconnect the power sensor whenever not in use.